Installation Instructions

9
Follow these steps to connect the antenna cable
and receiver to the interface box.
a. Connect the antenna cable (A) to the “To
KVH Antenna” jack on the interface box (see
Figure 17).
b. Connect an RF coaxial cable (B) from the
“Primary Receiver” jack on the interface box
to the “Satellite In” jack on the receiver.
c. Connect the receiver to the customer’s
television. Follow the instructions in the
receiver’s manual.
Do not shorten or extend the antenna cable.
Since the cable carries data, power, and
communications, the integrity of this cable
and its connections is very important.
IMPORTANT!
Be sure to route cables within the vessel
appropriately to avoid damage. For example,
do not route any cables through wet areas
(bilges) or near hot exhaust pipes. Also be
sure you do not kink the cable; maintain a
bend radius of at least 3" (75 mm).
IMPORTANT!
Satellite In
Antenna
Deck
Interface Box
Satellite TV Receiver
(A)
(B)
To KVH Antenna
Primary
Receiver
Figure 17: Wiring the Interface Box
Wire the Interface Box
7