Installation Instructions

7
Follow these steps to remove the shipping
restraint, which prevents the internal antenna
assembly from moving during shipment. The
antenna will not work with this restraint still in
place.
a. Remove the three #10-32 screws securing the
radome to the antenna.
b. Carefully lift the radome straight up until
clear of the antenna assembly and set it aside
in a safe place (see Figure 11).
NOTE: Due to the snug fit, some contact between the
radome’s sealing gasket and the antenna mechanism is
normal.
c. Using a 7/16" socket wrench, remove the
shipping restraint bolt, washer, and spacer
securing the antenna assembly to the base
(see Figure 12 and Figure 13). Save the
restraint for future use.
d. Position the antenna onto the mounting
surface. The antenna’s base should rest
squarely atop the foam seal.
Figure 11: Removing the Radome
Figure 12: Removing the Shipping Restraint
Washer
Bolt
Spacer
Figure 13: Shipping Restraint Hardware
Remove the Shipping Restraint
5