Installation Instructions

3
Before you begin, follow these steps to make sure
you have everything you need to complete the
installation.
a. Unpack the box and ensure it contains
everything shown on the Kitpack Contents
List. Save the packaging for future use.
b. Carefully examine all of the supplied parts to
ensure nothing was damaged in shipment.
c. Gather all of the tools and materials listed
below. You will need these items to complete
the installation.
• #2 Phillips screwdriver
• 7/16" open-end wrench
• 7/16" socket wrench
• 1/2" socket or open-end wrench
• Electric drill and 5/16" (8 mm) bit
• Hole saw of desired diameter (for cable
access hole, see page 5)
• Silicone sealant or equivalent
•Adhesive tape
• Light hammer
• Center punch
• Eight 1/4" fasteners (see “Mount the
Interface Box” on page 11)
• Satellite TV receiver
Always lift the antenna by the baseplate and
never by the radome or any portion of the
internal antenna assembly (see Figure 1).
IMPORTANT!
Interface Box/Controller
Radome
Baseplate
Antenna
Figure 1: TracVision M3/M2 System Components
Inspect Parts and Get Tools
1