Installation Instructions

12
Follow these steps to turn on the system for the
first time.
a. Ensure the antenna has a clear, unobstructed
view of the sky.
b. Apply power to the TV and the receiver.
c. Press the power switch on the front of the
interface box to apply power to the
TracVision system (see Figure 20).
d. Wait one minute for system startup.
e. Verify that the VOLTAGE and RECEIVER
status lights on the interface box are lit green.
Verify that the ANTENNA status light is
either lit green or flashing green (see
Figure 20). If not, refer to the User’s Guide for
troubleshooting information.
f. Verify that the “System Needs Setup” screen
is displayed on the interface box (see
Figure 21).
g. Using the buttons on the interface box front
panel (see Figure 22), follow the steps in the
next sections to set up the TracVision system
for the customer’s location and desired
satellites.
Figure 20: Interface Box Power Switch and Status Lights
Status Lights
Power Switch
ASTRA1
SYSTEM NEEDS SETUP
Figure 21: “System Needs Setup” Screen
Figure 22: Interface Box Buttons
Turn On the System
10