Installation Instructions

11
Once all cables are connected, follow these steps
to install the interface box inside the vessel.
a. Attach the two mounting brackets to the
sides of the unit using three #2-56 screws.
Simply screw these fasteners into the vent
slots (see Figure 19).
b. Secure the brackets to the mounting surface
using appropriate 1/4" fasteners (not
supplied).
NOTE: Be sure to leave enough slack in the
connecting cables (service loop) for easy serviceability.
Figure 19: Interface Box Mounting
Bracket
#2-56 x 1⁄4"
Screws (x3)
1⁄4" Fasteners (x4)
(not supplied)
To avoid overheating, do not block the upper
vents of the interface box.
IMPORTANT!
Mount the Interface Box
9