Satellite TV System User Manual

Set RF Tracking Parameters
Function: sets RF tracking parameter
Command: @SATCONFIG,X,N,F,S,C,ID,P,B,D<cr>
Response: Echoes the input data
Where: @SATCONFIG = directs data to the RF Board
X = satellite location A or B
N = satellite table # (98 & 99 are slots for user-
configured satellites)
F = frequency in MHz (either 00000 or a range from
10700 - 12700)
S = the satellite transponder symbol rate in
Mbit/second (01000 - 29999)
C = the FEC code (e.g., 12, 23, 34, 56, 67, 78)
ID = the satellite network ID in hexidecimal format
(0x####)
P = the LNB polarization (v=vertical, h=horizontal)
B = the LNB down conversion frequency (l=low,
h=high, u=US)
D = decoding type (0=test, 1=DSS-A, 2=DSS-B,
3=DVB)
ID Match/Decoded Network ID
Function: report ID match and decoded network ID
Command: @CHECKID
Response: Y,0X####
N,0X####
Y,NoID
N,NoID
Where: Y = yes
N = no
0X#### = network ID
NoID = satellite unidentified
F.6 Installation Commands
To execute the following commands, first put the Antenna Unit in
idle mode by typing
HALT and pressing “ENTER.” After the
system comes to a halt, type DEBUGON and press “ENTER” to
enter programming mode.
F-6
A Guide to TracVision L3