Satellite TV System User Manual

2-10
A Guide to TracVision L3
Power Cable-to-Switchplate Wiring Process
Find the TracVision L3 power cable (Cable #32-0590-30) where it
comes through the panel cutout made earlier. Wire the Antenna
Unit power cable to the switchplate connectors as indicated in
Figure 2-16. After wiring the power cable, connect the power
indicator lamp, also as noted in Figure 2-16. After both the power
cable and lamp are properly wired, carefully insert the lamp into
its socket immediately below the switchplate connectors.
2.3.3 Connecting to Vehicle Power
After completely wiring the indicator lamp and the data and
antenna cables, you must connect the switchplate to vehicle
power as pictured in Figure 2-17.
Before connecting the Antenna Unit
to vehicle power, remove the
appropriate vehicle fuse to prevent
a short circuit. After connecting to
vehicle power, replace the fuse.
Figure 2-16
Power Cable Wiring Arrangement
Figure 2-17
Vehicle Power Wiring
Arrangement
Make sure that all wires are
securely fastened within the
switchplate connectors.