Satellite TV System User Manual

2-5
Installation
54-0157 Rev. C
13. Reposition mounting plate over adhesive and
attach using
3
⁄16" (5 mm)-diameter rivets (or
appropriate fasteners). Seal all rivet heads and
edges with silicone.
14. Drill cable access hole(s) in vehicle.
15. When unit is installed with connectors facing the
rear of the vehicle, the drain holes are located as
shown in Figure 2-6.
Figure 2-6
Connectors Facing Rear
of Vehicle – Factory-drilled
Drain Hole Locations
Angle of Hole, relative to front
Angle of Hole, relative to front
Figure 2-7
Connectors Facing Front
of Vehicle – Recommended
Drain Hole Locations
You MUST drill out the drain holes
as indicated to ensure that any
moisture that enters the baseplate
is able to drain. Ensure that
factory-drilled holes are completely
sealed.
15a.(Alternate Drain Holes) If the Antenna Unit is
installed with the connectors facing the front of the
vehicle, drill out
3
⁄
16" (5 mm)-drain holes in rear-
facing side of baseplate as illustrated in Figure 2-7.
The existing factory-drilled drain holes shown in
Figure 2-6 must then be plugged with silicone
rubber sealant.