Satellite TV System User Manual

2-3
Installation
54-0157 Rev. C
4. While baseplate is in place, mark location(s) on
roof for cable access to permit convenient cable
access to the liquid-tight fittings on the back of the
baseplate.
5. Cut the tie-wraps holding the foam elevation
shipping restraint to the elevation axis motor shaft
(pictured in Figure 2-2) and remove the restraint.
6. Remove the three foam baseplate shipping
restraints securing the rotating plate, pictured in
Figure 2-3.
7. Remove six
1
⁄4-20 hex nuts and washers that secure
the Antenna Unit to the mounting plate.
8. Remove Antenna Unit from mounting plate.
9. The mounting plate allows the Antenna Unit to be
mounted on a curved roof. While the perimeter of
the mounting plate is secured to the vehicle with
Figure 2-1
Proper Orientation of
the Antenna Unit
Do not discard the foam shipping
restraints or shipping box. They
should be saved for future use in
case the Antenna Unit needs to be
removed and shipped to another
location.
Figure 2-3
Baseplate Shipping Restraints
Figure 2-2
Elevation Shipping Restraint