Satellite TV System User Manual

2-2
A Guide to TracVision L3
2.1 Choosing the Best Location
• The ideal antenna site has a clear view of the
horizon/satellite all around.
• Keep the antenna clear of any obstructions on the
roof (e.g., air conditioners).
• Consider the location of the antenna relative to the
location of any equipment or necessary wiring
within the vehicle.
• For best operation, mount the antenna on a
horizontal surface.
2.2 Mounting the Antenna Unit
The following instructions will result in a secure, effective
installation and trouble-free operation of your TracVision L3.
Table 2-2 lists the materials provided in the TracVision L3
kitpack. Most of these components will be used in the installation
process.
Part Qty. KVH Part No.
RF F-Connector 1 23-0170
Tie-wrap 5 22-0013
Flash kit cable and adapter 1 02-1029
Antenna Mounting Procedure
1. Remove Antenna Unit from shipping container.
2. Remove and save 8 pan head screws and flat
washers that hold radome to baseplate. Carefully
lift radome straight up until clear of antenna
assembly and set aside.
3. Position Antenna Unit in desired location on the
centerline of the vehicle with baseplate and
mounting plate arrows facing in the same
direction (either forward or backward). The proper
orientation is illustrated in Figure 2-1 on the
following page.
Table 2-2
Kitpack Contents
Always lift the Antenna Unit by
the gray baseplate, never by the
radome or any portion of the
antenna assembly!
The liquid-tight connectors on
TracVision L3 may face either
forward or backward along the
centerline of the vehicle for more
convenient installation.