TracVision G8 Owner's Manual

5.15 Replacing the Skew Motor

(Linear Quad LNB Systems Only)

1. Using a

⁄16" wrench, carefully disconnect the four RF

cables from the LNB.

Figure 5-25

Linear Quad LNB/Feed Tube Assembly

2. Disconnect the elevation and azimuth gyro cables from

the in-line connectors.

3. Disconnect the skew motor cable from the PCB module.

Figure 5-26

Skew Motor Cable Connector on PCB Module

Maintenance

54-0198

113

RF Cable

Connectors

LNB

Skew

Motor

#8-32 Screws (x 4)

POWER

ELEVATION GYROINTERNAL SENSOR SKEW MOTOR

ELEVATION & AZI MUTH MOTORS

AZIMUTH/ROLL GYROLIMIT SWITCHES

FUSE

Skew Motor

Cable Connector

Gyro Cable

Connectors