antenna system User's Guide

Wiring a Single TracVision Receiver
• DO NOT disconnect the short cable that connects
from one jack to another on the receiver’s rear
panel. The system will not work if this cable is
removed.
• You can connect the receiver to the entertainment
system using one of the following options:
Option 1 - RCA-type A/V jacks (use bottom row)
Option 2 - S-Video jack
Option 3 - RF coaxial connector
• Standard audio/video (A/V) cables with RCA-
type connectors are included with the receiver.
• Be sure to tighten all connections adequately.
• Before you connect the power wires, be sure to
read the important guidelines provided in the
Installation Guide (included with the system).
Connector Function
Vehicle Power Connect to input power (+12 VDC);
applies to a vehicle or a vessel
RF Remote Input Connect to RF converter
VHF Antenna In Not applicable for satellite TV; can
be used for over-the-air channels if
you have a TV tuner & VHF antenna
To KVH Antenna Connect to the TracVision antenna
Diagnostics Ports, Technician’s use only, for
Phone Jack diagnostics purposes
Audio R, Connect right (R) and left (L)
Audio L outputs to your audio component
Out to TV Tuner Connect to your TV if it only has an
RF (coaxial) connector and built-in
TV tuner
Video Connect to your TV if it has
standard RCA-type A/V jacks
(better picture quality)
S-Video Connect to your TV if it has an
S-Video input (best picture quality)
54-0287
A.5
System Wiring Diagrams
TracVision Receiver Rear Panel Connections