Datasheet

ManualsBrandsKvaser ManualsTest & MeasurementCurrent Clamp Adapter

Kvaser OBD II Adapter Cable





Connector P1: Molded OBD II Male Connector for Type B (24 Volt) and Type A (12 Volt)

Connector P2: Molded 9 Pin DSUB Female Connector with thumbscrews

Cable: 2500 mm long cable made of durable thermoplastic rubber.

Pin:

P1: OBD II P2: DSUB Signal Description Comments

4 5 Shield Shield

5 3 GND GND

6 7 CAN_H CAN H and CAN L are in a Shielded Twist

Pair

14 2 CAN_L CAN H and CAN L are in a Shielded Twist

Pair

16 9 Reference power Reference power is not needed for High-

Speed CAN.

All unused positions are populated

Warning: For use only in conjunction with Kvaser’s interfaces (or other interfaces, which isolate your computer from the vehicle's electrical system). Plugging the cable directly

into the PC may damage the serial port.