User Guide User guide

VHD Flybar

Description

VHD BASS ARM (KVV 987 307):

The VHD BASS ARM is a at steel bar with straight ends, a double groove joint at the lower end and

prexed apertures to accept both D6 & D12.6 QUICK RELEASE PINS.

This bar is used exclusively to suspend a compliment of two VHD Subwoofers and a single bar is used

on each side of the two enclosures.

The bar employs a total of four angular wedges that are used to ‘lock into’ the handles on each side of

the VHD Subwoofer enclosure and are secured by the insertion of a single D6 QUICK RELEASE PIN,

(Which are attached to the bar via small shrouded steel ties) into each handle.

VHD BASS EXTENSION ARM (KVV 987 308):

The VHD SUBWOOFER EXTENSION ARM is of the same design and presentation as the

VHD SUBWOOFER ARM, except it is dierentiated by being physically longer and employs a total of

four angular wedges to allow locking into an attached- secondary double hang of VHD Subwoofers

and its enclosure handles.

The same method of inserting a single D6 QUICK RELEASE PIN into each handle is employed.\

The arm has a poly-hex shape head at the top of the bar, with pre-xed apertures for the insertion of

the D12.6 QUICK RELEASE PINS, and is attached to the lower end of the VHD SUBWOOFER ARM by

sliding into the groove and then being secured by the insertion of a single D12.6 QUICK RELEASE PIN.

To add extra enclosures to the hang, this method of attachment is repeated.

STEEL PULL-BACK ARRESTOR:

A steel chain is used as a pull-back to assist with obtaining desired angles of hang.

Using the pre-set identication coloured links in conjunction with the example diagrams allows quick

and easy set-ups.

A small overhang chain collector bag is provided to protect and store the chain.

VHD 1.0 DOWNFILL ARM (KVV 987 310):

The VHD1.0 DOWNFILL ARM is a short, at pre-angled steel bar that has two pre-xed apertures at

the lower end of the bar to allow dierent angles of suspension from the enclosure above.

The arm is attached to the VHD1.0 down-ll enclosure by means of two apertures that receive the

insertion of two D6 QUICK RELEASE PINS.

The top of the bar is attached to the bottom of either the VHD2.0 TOP ARM or BASS/VHD2.0 ARM by

sliding into the groove and inserting a single D12.6 QUICK RELEASE PIN.

Description

VHD BASS ARM (KVV 987 307)

VHD BASS EXTENSION ARM (KVV 987 308)

VHD1.0 DOWNFILL ARM (KVV 987 310)