Owner manual

Power ON / Bass limit
This is a dual colour LED, when green it indicates that the AC power is on.
When red it indicates that the audio bass amplifier limiter has been activated.
Signal preset / Mid - Hi limit
This is a dual colour LED, green indicates when audio signal is present at the
EPAK2500’s input. When red it indicates that the audio mid-hi amplifier
limiter has been activated.
Thermal (auto reset)
When red it indicates that the thermal limit of the EPAK2500 has been
exceeded and the unit has shut down because of this.
BASS SECTION
Features
Upper panel
Page | 7
POWER ON /
BASS LIMIT
SIGNAL PRESENT /
MID- HI LIMIT
THERMAL
( AUTO RESET )
SYSTEM STATUS
0
-6dB
-3
+3
+6dB
BASS
MANAGEMENTBASS LEVEL
SET UP
EXTENSION
ATTACK
1X
2X
3X
SET UP
2x
ES2.5 or ES2.6
Sub Set Up
This switch is set according to which combination of subwoofers is being used with the system.
Refer to ‘Using the System’ for further information, the various combinations are listed in the table
within this section.
Bass Level
This is the level control for the Internal Subwoofer output; it is ‘post’ the Master Level control.
Managenent
This switch turns on the low frequency enhancement circuitry (EXTENSION position) which boosts
frequencies around 60Hz to enhance the lowest frequency band.
POWER ON /
BASS LIMIT
SIGNAL PRESENT /
MID- HI LIMIT
THERMAL
( AUTO RESET )
0
-6dB
-3
+3
+6dB
0
-6dB
-3
+3
+6dB
SYSTEM STATUS
BASS
SYSTEM
MAIN INPUT THROUGH SIGNAL OUT
2 PER SIDE
1 PER SIDE
MANAGEMENTBASS LEVEL MASTER LEVEL ES 1.0 SPEAKERS
SET UP
EXTENSION
ATTAC K
1X
2X
3X
SET UP
2x
ES2.5 or ES2.6