Installation Guide

INSTALLATION SHEET
LED Semi Flush Mount
START FROM HERE
SF15001
Please Note:
• This Kuzco LED fixtures come with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20191107
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
1. Remove fixture from its original package
2. Remove mounting plate (1c) from canopy (2a)
3. Attach mounting plate (1c) to electrical junction box (1a)
using screws provided (1e) in hardware package
4. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package and then place
driver (1f) inside junction box (1a)
5. Align mounting pins (1d) with spring clips (2c) on
mounting plate (1c) and twist to secure
2a.
1b.
1f.
1a.
1e.
1c.
1d.
2c.