Installation Guide

INSTALLATION SHEET
MP95105
LED Multi Pendant
START FROM HERE
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W
20200629
: kuzcolighting.com
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
To change fixture height, push and hold wire gripper
(2b), slide wire to desired length and then release
wire gripper (2b) to secure (Remove excess wire if
necessary)
Connect fixture (2d) to fixture hub (2c)
Remove the fixture from it’s original packaging
Secure canopy (2a) to mounting plate (1c) with
mounting screws (2f)
1.
Separate the mounting plate (1c) from within the
canopy (2a) by removing the mounting screws (2f)
2.
3.
Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire
nuts (1b) provided in hardware package
4.
Secure mounting plate (1c) to mounting surface
with anchors (1f) and screws (1g)
6.
Attach mounting plate (1c) to electrical junction box
(1a) using screws provided (1e) in hardware
package
5.
7.
8.
Fine tone wire length if necessary, by push and hold
wire gripper (2b) and then adjust wire to desired
length
9.
Please Note:
• All Kuzco LED fixture comes with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required.
2b.
2c.
2d.
1a.
1b.
1c.
1e.
2b.
1f.
1g.
2f.