Installation Guide

Remove the fixture from its original packaging
and remove the mounting plate (1c) from
within the hardware package. Attach the
mounting plate (1c) to the electrical junction
box (1a) on the ceiling using the two screws (1e)
provided in the hardware package.
Attach the fixture to the mounting plate, to the
electrical junction box on the ceiling. First attach
all wiring (2b) with the provided marrets
(white to white “N”, black to black “L”, ground
to ground “G”). Align the mounting plate
screws (1d) through the holes on the back of the
fixture (1a) and in a clockwise direction thread
nuts (2c) to the electrical junction box until the
fixture is secured to the ceiling.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20151217
Install the shade cover (2d) by placing it onto
the metal pan on the underside of the fixture
and turn clockwise until secure. (do not over tighten).
You have now completed the installation of your
fixture, enjoy.
INSTALLATION SHEET
FM7920
Ceiling LED Pendant
START FROM HERE
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
1.
2.
3.
4.
1b.
2a.
1a.
2c.
2d.
1c.
1d.
1e.