Installation Sheet

INSTALLATION SHEET
LED Flush Mount
START FROM HERE
.
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20210406
FM43414
1. Remove fixture from its original package
2. Attach crossbar (1c) to electrical junction box (1a)
using screws provided (1e) in hardware package
3. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package
4. Install Pan-Head Crossbar Mounting Screws (1d)
halfway into threaded holes on crossbar (1c). Align
keyholes on backplate (2a) and module to Pan-Head
Crossbar Mounting Screws (1d) heads, insert and turn,
and then secure with screw driver.
5. Secure backplate (2a) to ceiling with additional screws
(1g) and anchors (1f) if necessary
6. Twist shade (3a) onto backplate (2a) to secure
1a.
1b.
1c.
1e.
1d.
1f.
2a.
1g.
3a.
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all times during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required
• 120V input