Installation Guide

INSTALLATION SHEET
FM11410
LED Flush Mount
START FROM HERE
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
1.
2.
Remove the fixture from its original packaging. Next,
remove the mounting plate (1c) from within the
backplate (2b). First, loosen the three screws (2c) from
the canopy and remove the two screws (2b). Attach
the mounting plate (1c) to the electrical junction box
(1a) using the two screws (1e) provided in the
hardware package.
First connect all wires correctly G ground to ground, N
neutral wire (white to white), L live wire (black to black)
with provided marettes (1b) from the hardware
package. Attach the backplate (2a) to the mounting
plate (1c) by using the two screws (2b).
Lastly, install body (2d) to the backplate (2a). Align the
holes on the sides of the body (2d) to the holes on the
sides of the backplate (2a). Push the body (2d) up
towards the backplate (2a) and use the three screws
(2c) provided to secure.
You have now completed the installation of your fixture,
enjoy.
3.
4.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190206
1a.
1b.
1e.
2a.
1d.
2c.
2b.
1c.
2d.