Installation Guide

INSTALLATION SHEET

FM11015-WH

Round LED Flush Mount

START FROM HERE

Please Note:

• All Kuzco LED fixtures come with pre-wired LED module(s).

• Unless instructed to do so, please do not touch any part of the LED module(s) as any

unnecessary contact with the module could cause permanent damage.

• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.

CAUTION: HEAVY FIXTURE, THE JUNCTION BOX NEEDS TO BE REINFORCED

BEFORE INSTALLATION.

•

Make sure power is completely off at the fuse box.

•

Have your fixture installed by a qualified licensed electrician

•

Prepare everything in a clear area.

•

Wear gloves at all times during this installation.

•

Read instructions carefully before you start assembly.

•

Keep this instruction sheet for future reference.

Technical Support: 1-855-855-8926

Remove the fixture from its original packaging. Next,

remove the canopy mounting plate (1c) from the

canopy (2a) by un-threading the two nuts (2b).

Connect all wires (1b) correctly black to black “L”,

white to white “N” and the ground wire with provided

marrets from the hardware package. Secure the

mounting plate (1c) to the junction box with screws

(1e). Align the mounting plate threaded rods (1d)

with the holes on the surface of the canopy (2a).

Next, place the canopy (2a) to the mounting plate

(1c) screw in the nuts (2c) on to the mounting plate

threaded rods (1d), this will secure the canopy to the

mounting plate.

Lastly, connect the glass diffuser (3a) to the canopy

(2a) by turning clockwise.

You have now completed the installation of your

fixture, enjoy.

19054 28th Avenue Surrey, BC Canada V3S 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

20181227

: kuzcolighting.com