Installation Guide

INSTALLATION SHEET
FM10705
LED Flush Mount
START FROM HERE
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20160527
1.
2.
3.
Remove the fixture from its original packaging. Next,
remove the canopy mounting plate (1b) from within
the canopy (1d) by un-threading the two screws (2b).
You are now ready to mount the canopy to the
mounting plate. First connect all wires (1c) correctly
black to black “L”, white to white “N” and the ground
wire with provided marrets from the hardware
package. Align the mounting plate (1b) with the two
holes on the surface of the canopy (2d). Next, screw
in the two screws (1e) on to the mounting plate (1b),
this will secure the canopy to the mounting plate.
Connect the LED housing (2c) to the canopy (1d)
using the two screws (2b). Now, lift the LED cowling
(2d) up to the LED housing (2b) and thread clock-
wise.
You have now completed the installation of your
fixture, enjoy.
4.
1a.
1d.
2a.
2d.
2c.
2b.
1b.
1c.
1e.