Installation Guide

INSTALLATION SHEET
1.
Remove the fixture from its original packaging and remove
the mounting plate from within the hardware package. Now
secure the mounting plate (1a) to the box using the two
machine scews (1b).
2.
Attach all wiring (2a) with the provided marrets (white to white
“N”, black to black “L”, ground to ground “G”). Next, attach
the fixture (2b) to the mounting plate by threading the two set
scews (2c) until the fixture is secured to the ceiling.
3.
The next step is to install the cup diffuser onto the fixture.
With one hand, push the cup diffuser (3a) up against the
underside of the fixture (2b) and thread clockwise. Caution,
do not use exsisive force.
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20151229
START FROM HERE
▪
▪
▪
▪
▪
▪
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed
electrician
Prepare everything in clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED
module(s).
• Unless instructed to do so, please do not touch any part
of the LED module(s) as any unnecessary contact with the
module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) dimmer is
required.
3a.
2a.
Flush Mount Led
You have now completed the installation of your xture,
enjoy.
4.
1a.
2b.
FM10205
1b.
2c.