Installation Guide

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20160716
INSTALLATION SHEET
EW60307
Exterior LED Lamp Wall Sconce
START FROM HERE
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician
•
Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-877-452-6858
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
2a.
1c.
1b.
1a.
1d.
2d.
2b.
2c.
1e.
You have now completed the installation of your fixture, enjoy.
Remove the fixture from its original packaging. Remove
the mounting plate (1c) from within the canopy (2a) and
attach it to the electrical junction box (1a), using the two
screws (1e) provided in the hardware package.
Attach the canopy backplate (2a) to the mounting plate
(1c), which is attached to the electrical junction box (1a)
on the wall. First attach all wiring (1b) with the provided
marrets (white to white “N”, black to black “L”, ground to
ground “G”). Now direct the canopy backplate (2a) onto
the mounting plate (1c) be sure to line up the mounting
threaded holes (1d) with with the screws (2b). Next,
place the canopy (2d) onto the canopy backplate and
secure with all four set screws (2c) turning clockwise.
1.
2.
3.
To prevent moisture from entering the outlet box and
causing a short, seal around the top and side perimeter
between the fixture and the wall surface with weather
resistant caulking (see illustration 3). The space at bottom
should be left un-caulked to prevent moisture build-up.
4.
calking
illustration 3