Installation Guide

INSTALLATION SHEET
EC44505
LED Exterior Flush Mount
START FROM HERE
Please Note:
• All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
• Make sure power is completely off at the fuse box.
• Have your fixture installed by a qualified licensed electrician.
• Prepare everything in a clear area.
• Wear gloves at all times during this installation.
• Read instructions carefully before you start assembly.
• Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
19054 28th Avenue Surrey, BC Canada V3S 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20190312
1.
2.
3.
Remove the fixture from its original packaging. Next,
remove the mounting plate (1c) from the canopy (2a)
un-threading the decorative nuts (2b). Connect all
wires correctly black to black “L”, white to white “N”
and the ground wire with provided marrettes (1b) from
the hardware package.
Attach the mounting plate (1c) to the electrical
junction box (1a) on the ceiling using the two screws
(1d) provided in the hardware package. Secure the
canopy (2a) to the mounting plate (1c) using decora-
tive nuts (2b).
You have now completed the installation of your
fixture, enjoy.
1a.
1b.
1d.
2a.
1c.
2b.