Installation Guide

INSTALLATION SHEET

51561

Single lamp flush mount ceiling fixture

Remove the fixture from its original packaging. Remove the

canopy mounting plate from within the canopy and attach it

to the electrical junction box on the ceiling using the two

screws provided in the hardware package.

Now attach the fixture to the mounting plate, which is

attached to the electrical junction box on the ceiling. First

attach all wiring with the provided marrets (white to white

“N”, black to black “L”, ground to ground “G”). Push the

screws through the holes in the back of the fixture so they

are poking through into the center of the fixture. Once this is

complete you can tighten the screws (in a clockwise direc-

tion) until the fixture is secured to the ceiling.

You can now install the A-19 light bulbs of the correct wattage.

Now install the glass cover onto the fixture. (4a) The glass

cover is installed by hooking the three wire hooks on the side

of the fixture to the edge of the glass cover until the glass

cover is firmly secured to the fixture.

You have now completed the installation of your fixture,

please enjoy.

Install the metal ring to the fixture. Gently place the fixture,

and the glass, in the center of the metal ring until the metal

ring reaches the edge of the glass and fixture. Apply minimal

pressure to the ring until you hear a click and feel the ring

attach to the side of the canopy. (Please be careful to not

apply too much pressure as excessive pressure will cause

the fixture glass to crack or break.)

19054 28th Avenue Surrey, BC Canada V3S 6M3

T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196

W: kuzcolighting.com

4a.

START FROM HERE

▪

Make sure power is completely off at the fuse box.

Have your fixture installed by a qualified licensed

electrician

Prepare everything in clear area.

Wear gloves at all times during this installation.

Read instructions carefully before you start assembly.

Keep this instruction sheet for future reference.

Technical Support: 1-877-452-6858

PAGE 1
51561 Single lamp flush mount ceiling fixture 1. 2. 3. 4. 5. 6. Remove the fixture from its original packaging. Remove the canopy mounting plate from within the canopy and attach it to the electrical junction box on the ceiling using the two screws provided in the hardware package. Now attach the fixture to the mounting plate, which is attached to the electrical junction box on the ceiling. First attach all wiring with the provided marrets (white to white “N”, black to black “L”, ground to ground “G”).