M6 B6000 'LIFE TASTES GOOD' KUVINGS WHOLE SLOW JUICER A GLOBAL COMPANY MANUAL • • B77.JM6.ⓖ.2-131212M DE EN • After you read this manual, keep in the place you can reach easily. The color of product may vary. Household use only.
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: 1. 2. 3. 4. 5. 6. 03 04 06 08 10 12 13 14 18 20 21 22 24 Important Safeguards Safety Warning Parts How to Assemble How to Operate Tips on Operation Tips on Ingredient Ingredients Preparation How to Disassemble and Clean How to Clean Silicone Parts OPTIONAL | How to Use the Cleaning Tool Troubleshooting Q&A Specifications 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17.
SAFETY WARNING SAFETY WARNING Do not plug multiple power cords on a single outlet during operation. Do not put the parts in the dishwasher or extremely hot water. → It may cause and explosion or fire. →The parts may wear faster. Do not touch the power cord with wet hands. Do not repair, disassemble the base, or customize the appliance. → It may cause electrical shock. → The appliance may not operate properly causing fire, electrical shock, or injury. Do not use the appliance on an uneven surface.
PARTS * The products illustrated/photographed in this booklet may vary slightly from the actual product. Pusher Align 1. Feeding Tube 5. Smart Cap Detachable + Align the dots ● and slide the pusher in. 2. Drum Lid 3. Juicing Bowl 6. Base + STEP 1 Top-set Assembly + 4. Pulp Cup Align the red dots ● on each part and assemble in the order shown. Once assembled, turn the drum lid clockwise to close. 7. Juice Cup + 8. Rotation Wiper 9. Strainer 10.
HOW TO ASSEMBLE STEP 1 Top-set Assembly Check Before Operating 1 STEP 2 Top-set and Base Assembly • Wash the parts before first use. • Ensure that the compression silicone and silicone ring are assembled properly. Firmly insert the compression silicone into the slot below the pulp spout. 3 TIP For easy assembly hold the drum lid by grabbing the feeding tube and turn clockwise as shown in the illustration. 6 Open/Close mark on the top-set. Place the juicing screw into the strainer.
HOW TO OPERATE Note | STEP 2 Note | After preparing the ingredients, plug the power cord into a wall outlet. • Do not touch the power cord with wet hands. It may cause electrical shock, short-circuit, or fire. • Check the safety of the wall outlet. Press the FORWARD button to operate. • Forward: Pulls down and slowly masticates the ingredients. • Reverse: Pushes the ingredients back up to dislodge them. STEP 3 Note | • Fibrous leafy vegetables (celery, kale, etc.): » Separate each stem.
TIPS ON OPERATION 1. Operating the juicer without ingredients can cause damage to the screw. 2. Do not continuously operate the juicer for more than 30 minutes. This can damage the motor from overheating. After continuous use, let the juicer rest for 30 minutes to cool down before starting another session. 3. Do not put fingers or other objects into the feeding tube. Always use provided pusher when needed.
INGREDIENTS PREPARATION Before Operating: • Before Operating: If the juicer is jammed or if the drum lid does not open, press the REVERSE button and hold until it becomes dislodged. Repeat REVERSE-OFF-FORWARD as needed. • Continue operating the juicer until all the ingredients in the juicing bowl are extracted. The drum lid may not open easily if there is a lot of pulp remaining in the juicer. • Every ingredient yields different amounts of juice.
INGREDIENTS PREPARATION (e.g. raspberry, pomegranate, grape): Ingredients with small seeds | (E.g. apples, oranges & tomatoes) Fibrous and/or tough leafy ingredients (e.g. celery, kale, pineapple): | (E.g. apples, oranges & tomatoes) Slowly insert ingredients with small seeds to prevent the seeds from clogging the strainer. Fibrous ingredients like celery and kale should be cut into small lengths before juicing 4 inches For best result, juice with ingredients with higher amount of fluid(e.g.
HOW TO DISASSEMBLE AND CLEAN * The products illustrated/photographed in this booklet may vary slightly from the actual product. Note | 2 Note | 3 Switch OFF and unplug the power cord from the wall outlet. 4 • Extract all the remaining pulp in the juicing bowl before stopping the juicer. • For easier clean up, operate the juicer for an additional 30 seconds after the juice is extracted.
OPTIONAL | HOW TO USE THE CLEANING TOOL HOW TO CLEAN SILICONE PARTS * The products illustrated/photographed in this booklet may vary slightly from the actual product. | Clean the rotation wiper under running water. Thoroughly dry after cleaning. Before assembling the top-set, ensure that the compression silicone and silicone ring are firmly inserted. Note | If the compression silicone and silicone ring are not firmly inserted, juice may leak from the bottom of the juicing bowl.
TROUBLESHOOTING Q&A Low juice yield: • Different ingredients hold different amounts of fluid that will yield different amounts of juice. • If the ingredients are not fresh, they may contain reduced amounts of fluid, which will yield less juice. • Check if the compression silicone is firmly inserted. • If the ingredient itself has low water content, it may help to soak it in water before juicing. • If juicing ingredients with small seeds, after a few servings, it may reduce the juice yield.
SPECIFICATIONS Product Juicer Model NS-621CES Voltage AC220-240V, 50/60Hz Power Consumption 240W Maximum Use Less than 30 min Weight 6.4kg Dimension 228 x 208 x 448 (mm) Manufacturer NUC Electronics Co., Ltd. Type Low speed compression NUC Electronics Europe GmbH Am Kronberger Hang 3 65824 Schwalbach, Germany Email: info@nuc-eu.
