User's Manual

SECTION 7—OPERATION
7.6
7.2.1 TAGET LOCK - STATIONARY OPERATION
1. If the operator wishes to lock (retain) the violator's
speed, simply depress the LOCK switch on either the
remote control or the front panel. A short alert tone
will be heard and the target speed will be displayed in
the LOCK area.
The Raptor RP-1 will continue to track the violator's
speed in the Target area as long as the vehicle is in the
antenna beam.
The Raptor RP-1 will automatically run internal tests
prior to locking any speed. Depressing the Test(√)
switch will allow the unit to complete a display,
antenna, and internal test then return the locked speed.
If the operator switches to the opposite antenna while
Locked, the road graphic indicator for the selected
antenna at the time of lock will flash and the new
selected antenna will be on. If the operator changes
back to the original antenna, the original antenna
indicator will light steady.
While Locked the operator can not change the mode of
operation, such as stationary to moving.
2. To manually unlock or clear the locked speed, again
depress the LOCK/REL switch on either the remote
control or front panel. This will clear the LOCK
display area.
NOTE: If the auto-unlock option is enabled, the locked
speed will be automatically unlocked after 14
minutes.