User's Manual

SECTION 3—INSPECTION AND INSTALLATION
3.6
3.3.3 REAR ANTENNA MOUNTING
1. Place the antenna on the rear antenna mount.
2. Follow the procedure for determining any fan
interference per Sec. 3.3.2, steps 4-6. Set the Raptor
RP-1 for stationary ALL mode, rear antenna.
3. After the optimum position has been located (per Sec.
3.2.3 Step 6), secure the mount.
4. Position the antenna cable behind the rear seat and
under the rear floorboard, then route up to the
processing unit and connect. This method of
mounting will minimize the antenna from moving
around in the vehicle should it break loose in an
accident. It should also prevent anyone from using
the cable as a weapon against the officer.
5. Position the antenna parallel to the ground and
straight down the roadway.
NOTE: The polarization of the Raptor RP-1 K-Band
antenna is linear. For best results the antenna
must mounted with the aim site on the housing at
the top or bottom, not to the side.