User's Manual


14.4
14.2 OPTIONS EXAMPLES
Using the above options list, add all the numbers for the
options you want active. Note that default options, such as
MPH, have a value of zero (0). To enter the Options Menu
mode, power the unit off, then press and hold the POWER
switch until the power-on sequence stops at the Snc
display. Press the TEST switch three (3) times to advance
through the maintenance screens, until OPt appears in the
TARGET window and a number appears in the
FAST/LOCK window. This number may be zero.
Snc screen = speedometer synchronization value
CnF screen = configured features value
SFt screen = software version value
Opt screen = users selectable options value
Using the UP and DOWN arrows (AUDIO and RANGE
switches), increase or decrease the number for the value
needed. To make these changes permanent (until changed
again), depress the MODE switch once. When the options
have been accepted, the unit will automatically return to
radar mode.
EXAMPLE: The operator wishes to permanently change
the operation of the unit to the following: Automatic
Unlock = 1, toggle Fastest function = 16, Gateway
(unencrypted) output (F) = 32 and MPH = 0. These
numbers are added for a total of 49. When the menu
function is entered (see above), use the UP and DOWN
arrows to adjust the number shown in the FAST/LOCK
window until 49 is shown. The operator would then
depress the MODE switch and the changes would be
accepted and used every time the radar is powered up.