User's Manual


7.15
If on the other hand the unit is not in Hold for the typical
amount of time (less than one second), the region around
the saved patrol will be excluded from the initial patrol
search. While the last patrol speed is being rejected from
the search ‘re-‘ will be displayed in the Patrol window.
Example: If the patrol vehicle is traveling 25 MPH, there
is a strong approaching target traveling 45 MPH, and the
radar has mistakenly combined the two and is displaying
70 MPH for patrol. The operator can quickly go in and
out of Hold to reject the region around 70 MPH and the
correct 25 MPH patrol speed will be displayed.
7.8 MAINTENANCE MODE
The FalconHR has a maintenance/configuration mode
which can be used for diagnosis and configuration.
Holding the PWR switch depressed for 3 seconds or
longer during power up accesses this mode. Turning the
unit off and back on again will exit this mode.
7.9 TEST SCREEN MODE
The test screen mode is not for normal operations but is to
augment troubleshooting and test lab operations.
Pressing a combination of buttons can enter the test screen
mode. First press and release the TEST button. During the
test sequence, while all display segments are on, press the
RNG button. The unit will enter test screen mode, and the
TEST indicator will be on solid.
To exit test screen mode, press the MODE or TEST switch
or cycle power on the unit.