User's Manual

   
6.6
2. Momentarily press the TEST switch to enter the TEST
mode. The TEST indictor will be flashing while in the
TEST state. This allows the radar to detect a tuning
fork and bypasses the speedometer input if it is being
used.
3. Lightly strike the higher speed tuning fork on a hard,
nonmetallic surface and hold it in front of the antenna.
The PATROL window should display the speed
stamped on the fork, +1 mph (+1 km/h).
4. While holding the high speed tuning fork in front of the
antenna, lightly strike the lower speed tuning fork and
hold it in front of the antenna. The TARGET window
should display the sum of the higher and lower speed
tuning forks.
TARGET display tolerance is +1 mph (+1 km/h).
PATROL
TARGET
TEST
In Test mode the
TEST indicator
will flash.
Moving mode tuning fork
speeds are indicated in the
Target & Patrol windows