User's Manual

   
6.4
TARGET
TEST
In Test mode the
TEST indicator
will flash.
Stationary tuning fork
speed is indicated in the
TARGET window .
5. Repeat for the higher speed tuning fork.
NOTE: Since the FalconHR can determine these fork signals
are non-moving targets, the speeds displayed during
the fork tests cannot be LOCKED.
6.4.2 MOVING-OPPOSITE DIRECTION TUNING
FORK TEST
1. Place the unit in the dash mount or optional Pod and
select moving mode, opposite direction. (Press the
SAME/OPP switch on the remote, if necessary, to
select opposite direction.)
2. Ensure the HOLD indicator is off.
3. Momentarily press the TEST switch to enter the TEST
mode. The TEST indictor will be flashing while in the
TEST state. This allows the radar to detect a tuning fork
and bypasses the speedometer input if it is being used.