User's Manual

2
The Mic has a blue slide switch that is used to either 1) activate the audio system and start the
video recording, or 2) to mute the audio while in the record mode. When audio is activated, you
will feel a short “buzz” from the internal vibrator motor, and the LED’s will change to indicate
the active mode (see LED legend below). To mute the audio, slide the switch again – this will
result in two short buzzes from the internal vibrator.
When you stop a Recording by pressing the Stop button on the Control Center, the Digital
Wireless Audio will automatically return to the standby mode.
REMOTE TRANSCEIVER LED INDICATORS
LED 1 (closest to switch) LED 2 (middle) LED 3 (closest to logo) Vibrator Status
OFF OFF OFF N/A Power Switch OFF
RED GREEN BLUE N/A
Pwr on, unit in
Standby
GREEN GREEN BLUE 1 Long
System active,
Audio recording
RED GREEN BLUE 2 Short Standby or Muted
RED RED BLUE N/A
No Comm with
Base Station
OFF OFF BLUE N/A
Battery Saver
Mode**
Normal State Normal State Slow Blink BLUE N/A
Battery is low
recharging
required.
Blink GREEN OFF OFF N/A Charging Battery
GREEN OFF OFF N/A Charge Complete
Flashing RED OFF OFF N/A Charge Fault
** Battery Saver Mode is entered when the Remote has lost communication with the Base for 10 or more
minutes. This is to conserve battery life when an Officer is out of range for an extended amount of time.
Pressing the slide switch will exit this mode or the remote will exit it automatically when the Base Station
signal is received.
BASE STATION LED INDICATORS
LED 1 LED 2 LED 3 Status
N/A N/A BLUE Power is supplied to Base unit
RED GREEN BLUE Remote is in Standby or Mute
GREEN GREEN BLUE Remote Active and Audio is being
recorded
N/A Red then Flash
GREEN then
Solid GREEN
BLUE Remote is in Base Station and
“Association” is Complete