Product Manual

ManualsBrandsKushlan ManualsBuilding materials3.5 cu. ft. 3/4 HP 120-Volt Motor Direct Drive Cement Mixer

Operating Instruction and

Parts Manual for

350DD Epoxy

12010 Dairy Ashford Road, Suite 160

Sugar Land, TX 77478

281-313-2506 • 800-469-4178

WARNING

DO NOT ATTEMPT TO START OR OPERATE THE

MACHINE UNTIL ALL THE INSTRUCTIONS HAVE

BEEN READ AND UNDERSTOOD BY THE OPERATOR.

FAILURE TO DO SO COULD RESULT IN SERIOUS

BODILY INJURY AND/ OR PROPERTY DAMAGE!

Summary of content (8 pages)

PAGE 1
Operating Instruction and Parts Manual for 350DD Epoxy WARNING DO NOT ATTEMPT TO START OR OPERATE THE MACHINE UNTIL ALL THE INSTRUCTIONS HAVE BEEN READ AND UNDERSTOOD BY THE OPERATOR.
PAGE 2
SHOULD YOU REQUIRE ANY SET-UP OR OPERATING ASSISTANCE WITH YOUR PRODUCT, 2 DO NOT RETURN TO ORIGINAL PLACE OF PURCHASE •After referring to the operation manual, if assistance is still needed, please consult our web Site at www.kushlanproducts.
PAGE 3
Model 350DD Epoxy Parts List DESCRIPTION 3 QTY ITEM PART NO 1 350EP-01 Plastic Scraper 2 2 350EP-02 Scraper Holder 1 3 350EP-03 Polyethylene 3.5 Cu. Ft.
PAGE 4
Model 350DD Epoxy Parts List
PAGE 5
Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 Gearbox and Motor Assembly Parts List Part Number DD-808 DDMA-02 DDMA-03 DDMA-04 DDMA-05 DDMA-06 DDMA-07 DDMA-08 DDMA-09 DDMA-10 DDMA-11 DDMA-12 DDMA-13 DDMA-14 DDMA-15 DDMA-16 DDMA-17 DDMA-18 DDMA-19 DDMA-20 DDMA-21 DDMA-22 DDMA-23 DDMA-24 DDMA-25 DDMA-26 DDMA-27 DDMA-28 DDMA-29 DDMA-30 DDMA-31 DDMA-32 DDMA-33 DDMA-34 DDMA-35 DDMA-36 DDMA-37 DDMA-38 DDMA-39 DDMA-40
PAGE 6
Gearbox and Motor Assembly Parts List
PAGE 7
Assembly Instructions 7 Step 1 - Remove each wheel and face long end out. Thread axle through axle spacer which is between the wheels Step 2 - Attach washer with R clip, securing through hole on axle. Step 3 - Remove outer nuts, lock-washers & flat washers from the 4 studs on the motor gearbox assembly. Check inner nuts to make sure they are tight. (about 20ft. lbs of torque) Step 4 - Install motor gearbox on back of mixer frame with flat washers, lock washers and nuts to all 4 studs.
PAGE 8
Kushlan Products Limited Warranty Policy Kushlan Products makes every effort to assure that its products meet high quality and durability standards and warrants to the original retail consumer purchaser of our products (you) that each such product be free from defects in materials and workmanship as follows: ONE(1)YEAR limited warranty on motors. This warranty covers replacement of parts found to be defective in material or workmanship for a period of 90 days from the date of purchase.