User Manual

C--4
Theclipremovedfromthefuseholder:
Removethefuse.Installtwo250mAfastblowfusesfor230Vortwo500mAfastblowfusesfor
115V,oneoneachsideofthefuseholder.
Thefuseholderwillaccepteither1.25ʺX0.25ʺsizeor5mmX20mm
sizefuses.Ifusing5mmX
20mmsizefuses,insta llthemtowardstheinsideendofthefuseholdernearthemetalpins,as
shownhere:
Replacethefuseholderinthepowerentrymodulewiththeindicatorforthedesiredvoltage
towardstheedgeofthemodule,away
fromthepowerswitch.Closethefuseholdercover,and
checkthatthedesiredvoltageindicationshowsthroughthehole.Replacethepowercord.