User Manual

Keymap and Sample Editing
Editing Samples
14-11
Release Rate
Thereleaseratedetermineshowlongthesamplewilltaketodecaytozeroamplitudewhenthe
notetriggerisreleased.Thehigherthevalue,thefasterthereleaserate.Thisreleaseaffectseach
sampleindividually,andisineffectonlywhentheamplitudeenvelopefortheprogram(the
Modeparameter
ontheAMPENVpageintheProgramEditor)issettoNatural.Inthiscase,the
releasebeginsassoonasthenoteisreleased.IfModeisUser,thesettingsontheAMPENVpage
overridethesettingforReleaseRate.
Tocreateanextendedsampleloopthatwillplaydataafter
thesample’slooponkey‐up,setthe
AlternativeStartsamplepointerafterthesampleendpointer,thensetarelativelylowvaluefor
thereleaserate.
Loop Switch
Thisparameteractivatesordeactivatestheloopingofthecurrentlyselectedsample.Whensetto
On,thesamplewillloopaccordingtothe
settingsontheTRIMpage.WhensettoOff,the
samplewillplaythroughtoitsEndpointandstop.
Playback Mode (Playback)
Thisparameterletsyoumodify thedirectioninwhichthesampleisplayed.Setittoavalueof
ReverseifyouwantthesampletoplayfromitsEnd
(E)pointtoitsStart(S)point.Choosea
valueofBidirectionaltocausethesampletoplayfromStarttoEnd,thenreversedirectionand
playagainfromEndtoLoopandback,repeatinguntilthenotetriggerisreleased(thisworks
onlywhentheLoopSwitchparameterisset
toOn).
Alternative Sample Sense (AltSense)
Thisprovidesaconvenientwaytoactivatethealternativestartofasample.WhensettoNormal,
thealternativestartwillbeusedwhentheAltSwitchcontrolisOn(thisissetontheKEYMAP
page),orwhenthecontrolsourceassignedtoitisabove
itsmidpoint.WhensettoReverse,the
alternativestartwillbeusedwhentheAltSwitchcontrolisOff,orwhenthecontrolsource
assignedtoitisbelowitsmidpoint.
Ignore Release (IgnRelease)
WhensettoavalueofOff,thesamplewillreleasenormallywhenthenotetriggerisreleased.
WhensettoOn,thenotewillnotrelease,evenwhenthenotetriggerisreleased.Thissetting
shouldbeusedonlywithsamplesthatnormallydecaytosilence;nondecayingsampleswill
playforeveratthissetting.Thisparameterisequivalenttothe IgnReleaseparameteronthe
LAYERpage,but
affectsonlythecurrentlyselectedsample.
SampleRate and NumSamples
Theseparameterscannotbeedited,butshowthesample’ssamplerateandthesample’slength
insamples.Samplesthatarelongerthan1millionsamplesaredisplayeda1Ms.
The Soft Buttons on the MISC Page
Rename
Callupthepagethatenablesyoutochangethenameofthecurrentsample.
Save
Starttheprocessofsavingthecurrentsample.
Delete
Deletethecurrentsamplefrommemory.FactoryROMsamplescannotbedeleted.