User Manual

ManualsBrandsKurzweil ManualsWorkstationPC3 K7 + Kore64 e PC2RIB in Omaggio

211

212

213

214

215

216

217

218

219

220

Effects and Effect Mode

Effect Mode and the Effects Pages

9-7

Output

Thisparameterspecifiesthephysicalaudiooutputpairforthepage’scorrespondingAux

Chain’soutput.ThesettingsPri.andSec.refer,respectively,totheprimaryandsecondary

physicalaudiooutputsofthePC3K(labeled“MAIN”and“A U X ” onthebackpanel.)Setting

Outputtoautousestheoutputpairspecified

intheprogramonthecurrentchannel(orthe

programonthespecifiedAuxEffectschannelinSetuporSongmode).

Mod Override

ThisparametercanbeusedtooverridetheModControlsourceoftheprogramonthecurrent

channel(ortheprogramonthespecifiedAuxEffectschannelinSetup

orSongmode.)Setaphysical

controllerorotherModControlsourcetoscaletheAuxsendlevelbetween‐96dBandthevalue

setfortheauxsendlevel.AsettingofNoneyieldsnooverrideinModControlsource,anduses

theModControlsourcespecifiedintheprogramon

thecurrentchannel(ortheprogramonthe

specifiedAuxEffectschannelinSetuporSongmode.)

Send Levels and Pre/Post Ins.

Onthebottomhalfofthepage,therearetwoparametersforeachofthe16MIDIchannels:Send

Level(toprow)andPre‐/Post‐Insert(bottomrow).

ThesettingforeachSend

LevelparameterdeterminesifeachchannelsAuxSendLevelis

overridden,andifso,bywhatvalue.Avalueof[p]means“nooverride”(i.e.,usethevalues

specifiedintheprogram).Avalueof[p]canbesetbyentering‐99withthealphanumericpad

andthenpressingthe

Enterbutton,orbyusingtheAlphawheelor‐/+buttonstoscrollbelow

‐96db.

Note:InmostfactoryROMprograms,thesendlevelforAux1iscontrolledbyanAuxmodset

toMIDI28(sliderI.)Ifasendleveloverrideisset,itwillusuallybescaledby

theentryvaluefor

sliderIeachtimeaprogramisselected.Todefeatthisbehavior,setthe ModOverrideparameter

toON,thensettheSendLeveloverridevalue.

ThesettingforeachPre‐/Post‐InsertparameterdeterminesiftheAuxroutingforeachchannelis

overridden,andif

so,bywhatrouting.PremeansthattheAuxSendtakesplacebeforeany

InsertEffectisapplied,whereasasettingofPstmeansthattheAuxSendtakesplacepost‐Insert

Effect.(Ofcourse,iftheprogramonthechannelhasnoInsertEffectsloaded,thenthis

parameterwillmake

nodifference.)Avalueof[p]means“nooverride”(i.e.,usethevalues

specifiedintheprogram).