User Manual

9-6
Effects and Effect Mode
Effect Mode and the Effects Pages
Override
ThisparameterswitchesonorofftheAuxoverride.SetOverridetoYestoselectanoverride
AuxChainonthispage(theChainparameterappears,seebelow.)SetOverridetoNotousethe
auxchainsoftheprogramonthecurrentchannel(ortheprogramonthespecified
AuxEffects
channelinSetuporSongmode.)IfOverrideissettoNo,thetoplineofthepagedisplaystheAux
Chainthatisloadedforthecurrentprogram,aswellasthecurrentchannel.Inthecaseofthe
pageshownabove,theAux1Chainof
thecurrentprogramis906MediumHall2,andthe
currentchannelis6.
NoticethatinProgrammode,ifanAuxeffectisoverriddeninEffectmode,thetoplineofthe
PROGFX(orLYR_FX)page(intheProgramEditor)indicatesthatcorrespondingChaindoesnot
useupanyDSP
units.SincetheChainspecifiedfortheprogramisnotapplied,thePC3Kdoes
notallocateresourcesforit.
Chain
WhenOverrideissettoYes,youcanselectanoverrideAuxChainforthepage’scorresponding
Auxbus.ThisparameterisnotvisiblewhenOverrideissettoNo.
Parameter Range of Values Default
Override No, Yes No
Chain Chain List 0 None
Output auto, Pri., Sec. auto
Mod Override Control Source List None
Send Level [p], -96 to 24 dB [p]
Pre-/Post- Insert [p], pst, pre [p]