User Manual

7-32
Setup Mode
The WHEEL Page
The WHEEL Page
Thetwowheelsaretypicalofwhat isfoundonmanykeyboards.Theleftoneisnormallyused
forpitchbendandspringsbacktocenter,whiletherightwheelisnormallyusedasastandard
ModWheel.OntheWheelpageintheSetupeditor,thepitchwheelhastwo
parameters—one
forpushingthepitchwheelupandoneforpushingitdown—whereasthemodwheelhasone.
TheWHEELpageparametersaredescribedinContinuousControllerParameters on page 7‐29.
Parameter Range of Values Default
Destination (PWUp) Control Destination List PitchUp
Destination (PWDn) Control Destination List PitchDwn
Destination (MWhl) Control Destination List MWheel
Scale ± 300% 100%
Add -128 to 127 0
Curve Linear, Compress, Expand Linear
Entry Value None, 0 to 127 None
Exit Value None, 0 to 127 None