User Manual

Setup Mode
Controllers
7-25
159 ArpGliss Arpeggiator Gliss, 0-63 = off, 64-127 = on. (See The
ARPEGGIATOR 2 Page on page 7-49)
160 SusLatch For Arpeggiator Latch Pedals mode, 0-63 = off, 64-127 = on.
(See The ARPEGGIATOR 2 Page on page 7-49)
161 Panic Panic
162 SoloZn Solo Zone
163 RiffOn Riff On (See Riffs on page 7-55)
164 RiffOff Riff Off (See Riffs on page 7-55)
165 RiffDur Riff Duration (See Riffs on page 7-55)
166 RiffVel Riff Velocity (See Riffs on page 7-55)
167 RiffDly Riff Delay (See Riffs on page 7-55)
168 TapTempo Tap Tempo (See TEMPO on page 11-11)
169 KB3Mutes KB3 Mutes—in Setup Mode, values of 63 and below disable
the Bank buttons for controlling KB3 programs in that setup,
and a values above 64 enable them
170 -Arp Shift Sets ARPEGGIATOR values for Shift to negative. 0-63 = off,
64-127 = on. (SeeThe ARPEGGIATOR Page on page 7-42)
171 ShiftPatt Selects one of the 128 patterns in the current
ARPEGGIATOR ShiftPatt Bank. (See The ARPEGGIATOR
Page on page 7-42)
172 ShiftPBank A controller value selects the corresponding ShiftPatt Bank
for the ARPEGGIATOR page of a controller’s zone. For
example, controller value 2 selects ShiftPatt bank 2,
controller value 7 selects ShiftPatt bank 7.(SeeThe
ARPEGGIATOR Page on page 7-42)
173 VelPatt Selects one of the 128 patterns in the current
ARPEGGIATOR VelPatt Bank. (SeeThe ARPEGGIATOR
Page on page 7-42)
174 VelPBank A controller value selects the corresponding VelPatt Bank for
the ARPEGGIATOR page of a controller’s zone. For
example, controller value 2 selects VelPatt bank 2, controller
value 7 selects VelPatt bank 7.(SeeThe ARPEGGIATOR
Page on page 7-42)
175 VelFixed Set’s arpeggiator velocity when ARPEGGIATOR velocity is
set to Fixed. (SeeThe ARPEGGIATOR Page on page 7-42)
176 ShKeyNum Shift Key Number (see below)
177 ShiftKey Shift Key (see below)
178 ShKeyNuV Same as 176 ShKeyNum, but the Shift Pattern’s velocity will
be modified by the current velocity pattern of the zone.
Controller
Number
Corresponding
Destination
Name
Description
Table 7-4 Controller Destination List (Continued)