User Manual

ManualsBrandsKurzweil ManualsWorkstationPC3 K7 + Kore64 e PC2RIB in Omaggio

141

142

143

144

145

146

147

148

149

150

7-18

Setup Mode

The BEND Page

TheparametersontheBENDpagedefinethebendrangesforeachofthethreetypesofpitch

bendmessagesthePC3Kcanrespondto.

Bend Range (Semitones) and Bend Range (Cents): Up and Down

BendRangeUp(ST)andBendRangeDown(ST)sendsabendrangemessagetoaninternal

programoraMIDIdevice,tellingithowtodefinesubsequentpitchbendmessages.Some

programsmaybehavestrangelywhenyouchangetheBendRangevalue,becausetheyuse

FUNsorDSPFunctionstoaffectthepitchwheel.Inthat

case,youshouldeithersetthevalueof

BendRangetoProg,oredittheprogramitself.

NOTE:ThesettingsforBendRangeUpandDownareonlyreflectedinSetupmode.Evenifyouspecify

BendRangeUpandDownvaluesforthecontrolsetup(setupassignmentswhicharespecifiedinSetup

mode

andusedinProgrammode,)bendrangevalueswillnotbereflectedinanymodeexceptSetupmode,

andpitchbendmessagesinthecurrentprogram(inProgrammode)willresultinbehaviorasspecifiedfor

thePitchBendRangeparametersontheCOMMONpageintheProgramEditor.

BendRangeUp(ct)and

BendRangeDown(ct)letsyoufinetunethevalueforBendRange

(semitones).100centsequalsonesemitone,oronehalf‐step;youcansetthisparameter

anywherebetween0and100cents.

BendRangeUp,inbothsemitonesandcents,affectsallcontrollersthataresettoPitchUp(inthe

defaultcontrolsetup,the

PWUpparameterontheWHEELpageisassignedtoPitchUp).

BendRangeDown,inbothsemitonesandcents,affectsallcontrollersthataresettoPitchDwn

(inthedefaultcontrolsetup,thePWDnparameterontheWHEELpageisassignedto

PitchDwn).AnyphysicalcontrollerthatusestheControlDestinationlistcan

beassignedto

PitchUporPitchDwn.Tokeepthingssimplethough,youwillnormallywanttousePitchUp

Parameter Range of Values Default

Bend Range Up (semitones) Prog, 0 to 127 semitones 2

Bend Range Up (cents) Prog, 100 cents 0

Bend Range Down (semitones) Prog, 0 to 127 semitones 2

Bend Range Down (cents) Prog, 100 cents 0

Aux Bend 1 Up 0 to 60 semitones 12

Aux Bend 1 Down 0 to 60 semitones 12

Aux Bend 2 Range 0 to 60 semitones 2