User Manual

7-8
Setup Mode
The Channel/Program (CH/PROG) Page
Entry Program Change (EntryProgChg)
Thisparameterenablesordisablesbankandprogramchangecommandssenttointernal
programsortotheMIDIOutjackwhenyouselectsetups.Ifit’ssettoOn,theprogramnumbers
fortheprogramsinthe16zoneswillbesentviaMIDIwhenasetupisselected.By
settingthis
parametertoOff,youcanselectasetuponthePC3K withoutchangingtheinternalprogramsor
thoseonMIDIdevicesreceivingfromthePC3K.Thisisusefulifyouwanttosendonly
controllerdatatothePC3KortoMIDIdevices,withoutchangingprogramas signments.
Arpeggiator
TheArpeggiatorparameterdeterminesifthecurrentZonecanbeplayedbyanarpeggiator.
Normally,theArpeggiatorparametershouldbesettoOn,andthearpeggiatorforeachZone
shouldbeturnedonoroffwiththeActiveparameterontheARPEGGIATORpageforeachZone
(seeTheARPEGGIATORPage on page 7
‐42fordetails.)IftheArpeggiatorparameterissettoOff,
thezonewillnotbearpeggiatedeveniftheActiveparameterontheARPEGGIATORpageisset
toOn.
Whenaglobalarpeggiatorisbeingused,theArpeggiatorparametercanbesettoOfftoexclude
aZone
frombeingplayedbytheglobalarpeggiator.SeeArpeggiatorGlobal
(ArpGlobal) on page 7‐66fordetailsonsettingaglobalarpeggiator.