User Manual

7-6
Setup Mode
The Channel/Program (CH/PROG) Page
MIDI Program (MidiProg)
MidiProgdefineswhichprogramnumberistransmittedouttheMIDIOutportonthecurrent
zone’sMIDIchannel.
WhenyouchangethevalueoftheProgramparameter,thevalueofMIDIProgautomatically
changescorrespondingly.IfyouwanttotransmitaMIDIprogramchangenumberdifferent
fromtheonecorrespondingtothe
localprogram,selectthelocalprogramfirst,thenchangethe
MIDIprogram.
DifferentprogramsareaccessibledependingonthevalueoftheBankModeparameter:
Status
ThisparameterdetermineswhatthecurrentzonedoeswhenyouselectthesetupinSetup
mode.Mutedmeansthatthezonesendsandreceivesprogramchangesandentry/exitcontroller
values,butdoesn’tplaynotes.IfthevalueisActive,thezonesendsandreceivesnormallyvia
MIDI.Solocausesonly
thecurrentzonetoplay,“backgrounding”allotherzones
(backgroundedzonessendandreceiveprogramchangesandentry/exitcontrollervalues,but
don’tplaynotes).WithavalueofSolo+Muted,thecurrentzoneisbothsoloedandmuted;when
thezoneisn’tsoloed,itwon’tproducesound).
Seethesectionaboutzone
‐statusLEDs(page 7‐2)formoreinformationabou tmutingand 
soloingzones.
Out
UsetheOutparametertosettherearpanelaudiooutputsusedforeachzoneofthecurrent
Setup.Thisparameterdeterminestheoutputsettingsforthemainprogramsignalandinsert
effectsofeachzone(forAuxeffectsoutputsettings,usetheOutputparameterontheSetup
ModeAUX1or
AUX2pages.)
AsettingofAutowillmakethatzoneoutputaudiobasedonthesettingsfortheprogramused
bythatzone.ProgramoutputsettingsaresetintheProgramEditorusingtheOutputparameter
onthetoplineofPROGFXpage(seeOutput on page 6‐48fordetails)or
theOutputparameter
ontheLAYERFXpage(seepage 6‐49fordetails.)AsettingofPri.(primary)willoutputtrack
audiototheMAINBalancedAnalogOutputs.AsettingofSec.(secondary)willoutputtrack 
audiototheAUXBalancedAnalogOutputs.
Input Channel
InSetupmode,anexternalMIDIdevice(suchasakeyboardorsequencer)willplaynotesofa
singleprogrambydefault(iftheLocalKeyboardChannelparameterissettooff,seepage 10‐10
fordetails.)TheplayedprogramwillbeonaZonethathasaChannelparameter(on
theCH/
PROGpage)whichmatchesthechannelonwhichtheexternalMIDIdeviceistransmitting.(If
noZone’sChannelparametermatches,theexternaldevicewillplaynotesofthelastprogramthatwas
usingthatchannelinProgramModeorfromapreviouslyloadedSongorSetup.)
Value of BankMode Available Programs
Ctl 0 or Ctl 32 0 to 127
Ctl 0/32 0 to 127
K2600 0 to 99
None None