User Manual

7-4

Setup Mode

The Channel/Program (CH/PROG) Page

ThisisthefirstpageyouseewhenyouentertheSetupEditor.Here,youcanselectprograms,

MIDIchannels,andMIDIBanknumbersforeachofthesetup’s16zones.Youcanalsosoloor

muteeachzone.

Program

Thisselectsaninternalprogramtoplayoneachzone.AsyouchangethevalueofProgram,

noticethatMIDIProgramandMIDIBankmatchthelocalprogramandbank numbers

(programs1–127fallintoMIDIBank0,128–255fallintoMIDIBank1,andsoon—bothMIDI

BanksandPC3K

bankscanhold128programs).Ifyouwanttotransmitdifferentprogramand

banknumbersoverMIDI,highlighteitherMIDIProgramorMIDIBankandselectanewvalue.

NotethatchangingtheProgramparameteragainwillresetboththeMIDIProgramandMIDI

Bankparameterstomatchthelocal

programandbanknumbers.

NOTE:MIDIBanksandPC3Kbanksarenotthesame,noristhereadirectone‐to‐onecorrespondence

betweenthetwo.Asmentionedpreviously,programs1–127fallintoMIDIBank0,programs128–255

fallintoMIDIBank1,andsoon;programIDs1–128fallinto

PC3KbankBase1,programs128–255fall

intoBase2,andsoon(recallthatthePC3Kbankname saredisplayedinleft‐to‐rightorderabovetheir

correspondingBankbuttonsabovethesliders.)Forexample,program127MagicCelesteisinPC3K

bankBase1anditisProgram127

inMIDIBank0;andprogram128Drums‘nBellsisinPC3Kbank

Base1,anditisProgram0inMIDIBank1.

Parameter Range of Values Default

Program Program List 1 Standard Grand

Destination Destination List USB_MIDI+MIDI+Local

Channel 1 to 16 1

MIDI Bank 0 to 127 0

MIDI Program (MidiProg) (Depends on MIDI Bank Mode) 1

Status Muted, Active, Solo, Solo+Muted Active

Out Auto, Pri., Sec. Auto

InputChannel None, 1-16 None

MIDI Bank Mode (BankMode) MIDI Bank Mode List Ctl 0/32

Entry Program Change (EntryProgChg) On, Off On

Arpeggiator On, Off On