User Manual

6-68
Program Mode
KB3 Editor: The MISC Page
LeakMode
Selectsbetweendifferentleakagemodels,determiningwhichleakageharmonicsare
emphasized.TypeAprovidesanoveralltonewheelleakage,withalltonewheelsleakingasmall
amount.TypeX,TypeY,TypeZ,andTypeRemulatedifferentdegreesofdrawbarleakage,where
theleakagecomponentscorrespondtotheninedrawbars,insteadofallthe
tonewheels.
SpeedCtl
SelecteitherFastorSlowtochoosethespeedoftherotaryspeakeremulation.Youcantoggle
betweenfastandslowspeedusingBankbutton1(labeledRotaryFast/Slow.)Bankbutton1also
sendsandrespondstoMIDICC68;avalueof64‐127=Fast,and0‐63
=Slow.
VibChorCtl
ChooseOnorOfftoturnonoroffeithervibratoorchorus(asselectedwiththeVibChorSel
parameter).YoucantogglebetweenonandoffusingBankbutton2(labeledVibratoOn/Off.)
Bankbutton2alsosendsandrespondstoMIDICC95;avalueof64‐127=
On,and0‐63=Off.
VibChorSel
Choosethevibratoorchorusprogram(therearethreeofeach)youwishtousewiththisKB3
program.NotethatyoumustsetVibChorCtl(alsoontheMISCpage)toOntoheartheeffect.
YoucanselectthevibratoorchorusyouwantusingBankbuttons3and4
(labeledVibratoChor/
VibandVibratoDepth.)
Bankbuttons3and4alsosendandrespondtoMIDICC93;values54‐71=choruswithdepth1,
values72‐89=choruswithdepth2,values90‐127=choruswithdepth3,values0‐17=vibrato
with
depth1,values18‐35=vibratowithdepth2,values36‐53=vibratowithdepth3.
VolAdjust
ProvidesanoverallvolumeadjustfortheKB3model.Usethisparameterto“normalize”KB3
programswithotherprograms.
BendRngUp, BendRngDn
RespectivelycontroltheupwardanddownwardpitchbendrangesoftheKB3program.
Sustain
Set On or Off to enable or disable response to MIDI sustain (MIDI 64). By default MIDI sustain (MIDI
64) is sent by Switch Pedal 1.
Sostenuto
Set On or Off to enable or disable response to MIDI sostenuto (MIDI 66). By default MIDI sostenuto
(MIDI 66) is sent by Switch Pedal 2.
LesliePedal
Set the pedal source (Sustain=Switch Pedal 1, CC 64 by default, Sost=Switch Pedal 1, CC 66 by default,
Soft=Switch Pedal 3, CC 67 by default) to toggle between Fast and Slow for the Leslie™ speaker rotation
speed.