User Manual

ManualsBrandsKurzweil ManualsWorkstationPC3 K7 + Kore64 e PC2RIB in Omaggio

101

102

103

104

105

106

107

108

109

110

6-50

Program Mode

The Controllers (CTLS) Page

PresstheCTLSsoftbuttontocalluptheCONTROLLERSpage.TheCONTROLLERSpage

showsalistofthePC3K’scontrollers(sliders,Modwheel,switch,etc.,)whichcanbeusedto

controlprogramparameters.Usethispagetosetvaluesforeachcontrollerthatwillbesaved

withtheprogram(entry

values.)Whenaprogramisloaded,theentryvaluesonthispageare

senttoanyprogramparametersthathavebeenassignedtothesecontrollers.

Forexample,theelectricpianoprogram25WoodstockClunkerhasTremoloDepthassignedto

becontrolledbytheModWheel.TurninguptheModWheelincreases

theTremoloDepthand

allowsyoutohearmoreoftheTremoloeffect.Ifyoulook attheCONTROLLERSpagefor

25WoodstockClunker,Modwheel(1)issetto37.ThismeanstheModWheelsendsavalueof

37tosetTremoloDepthwhentheprogramisselected,allowingyou

toheartheTremoloeffect.

IfyoudonotwanttoheartheTremoloeffectwhentheprogramisselected,edittheprogram

andusetheCONTROLLERSpagetosetModwheel(1)to0,thensavetheprogram.

ForcontrollersthathaveanentryvaluesettoNone,no

valueissentforthatcontrollerwhena

programisloaded.WhenandentryvalueofNoneisused,thevaluelastusedforthatcontroller

(inthepreviousprogramorsetup)isused.TosetavalueofNone,usethealphawheelor‐/+

buttonstoscrollbelow

0,orusethealphanumericpadtoenter‐1,thenpresstheEnterbutton.

Youcanautoma ticallysetthevaluesontheCONTROLLERSpagetothephysicalcontrollers

currentvaluesbyusingtheSetCtlsoftbutton(locatedtotherightoftheCTLSsoftbutton.)The

SetCtlsoftbuttoncaptures

thepositionsofthecontrollerslistedonthepage.

Note:Ifyouchangeprograms,andthenpresstheSetCtlsoftbuttonbeforemovinganyofthe

controllers,theparametersontheCONTROLLERSpagewillremainattheirpreviouslyset

values.

Thenumberinparenthesesthatappearsnexttoeachcontrollername

istheMIDIcontroller

numberthateachcontrollertransmitsbydefault,i.e.,withtheControlSetupsetto126Internal

Voice sontheMIDImodeTransmitpage.SeeControlSetup on page 6‐9fordetails.

Controller Range of Values Default Value

Slider A (6)...Breath (2) None, 0-127 0

Switch 2 (29) None, 0, 127 0