User Manual

Program Mode
The Layer FX (LYR_FX) Page
6-49
Aux1 Mod, Aux2 Mod
TheAuxModparametergivesyoureal‐timecontrolovertheamountofprogramsignalsentto
theauxeffectschain.YoucansettheAuxModparametertoanyPC3Kcontrolsource.The
amountthatyouspecifyfortheAuxSendparameteristhemaximumvaluethattheAuxMod

controlsourcecansend—theminimumvalueis0.
The Layer FX (LYR_FX) Page
PresstheLYR_FXsoftbuttontocalluptheLayerFX(LYR_FX)page.Onthispage,youcan
applylayer‐specificeffects.TherearethreeLayerFXModes:UseProgramFX,Layer‐Specific
FX,andUseAnotherLayer’sFX.
Use Program FX Mode
WithUseProgramFXModeselected,thecurrentlayerwill
usetheeffectsconfiguredonthe
ProgramFX(PROGFX)page.SeeTheProgramFX(PROGFX)Page on page 6‐47formore
informationonprogramFX.
Layer-Specific FX Mode
WithLayer‐SpecificFXselected,youcanconfiguretheeffectsforthecurrentlayer.Thismode’s
parametersaresimilartothoseofthePR OGFXpage.Thismode
isshowninthefollowing
display:
AlloftheLayer‐SpecificFXmodeparametershavethesamefunctionsandrangesofvaluesas
theircorrespondingparametersonthePROGFXpage.SeeTheProgramFX(PROGFX)
Page on page 6‐47formoreinformationontheseparameters.
Use Another Layer’s FX Mode
WithUseAnotherLayer’sFXselected,youcan
putthecurrentlayerthroughtheeffectsof
anotherlayer.Youcanspecifythelayerthroughwhoseeffectsyouwishtoputthecurrentlayer.