User Guide

3-12
Playing Your PC2R
Program and Setup Organization
You can set the following parameters for each channel. See page 5-33 for more information
about using MIDI Receive mode.
• Channel On/Off
• Program
• Volume
• Pan
• Effects routing
• Wet/Dry mix from output of FX-A to input of FX-B
• Wet/Dry mix to input of FX-A
• Wet/Dry mix to input of FX-B
Global
The Global button takes you to a list of parameters and functions affecting the entire PC2R
There’s a description of each global parameter/function beginning on page 5-35.
Demo
Press MIDI Receive and Global together to enter a special demo mode. Then press Main or
Layer (in the Performance region) to play a demo sequence. Press Cancel to stop playback, or to
exit from demo mode.
Panic
Press KB3 and MIDI Setups together for the “Panic” function. This sends All Notes Off
messages and All Controllers Off messages on all MIDI channels—both to the PC2R’s sound
engine and to its MIDI Out port.
Program and Setup Organization
The PC2R’s programs and setups are arranged in banks; each bank can contain 128 programs or
setups. The PC2R has a total of eleven banks, as shown in the following table:
Mode
Bank
ID
Bank
Name
Bank
Contents
Comment
Internal
Voices
0 Internal Programs 0–127 Factory programs
1 User Empty Can store 128 user-defined programs numbered 0–127
2 Exp1 Empty Reserved for internal programs contained in future expansion block
3 Exp2 Empty Reserved for internal programs contained in future expansion block
6 Int2 Programs 0–127 Factory programs
KB3
4 Internal
KB3 programs
0–120
Total of 16 factory KB3 programs, numbered in increments of 8
5 User Empty Can store 128 user-defined KB3 programs numbered 0–127
MIDI
Setups
0 Internal
Setups 0–32
and 125–128
Factory setups
1 User Empty Can store 128 user-defined setups numbered 129–256
2 Exp1 Empty Reserved for factory setups contained in future expansion block
3 Exp2 Empty Reserved for factory setups contained in future expansion block