User Guide

Table Of Contents
Descriptions of Parameters
Setup Editor Parameters
5-25
On Controller (On Ctrl)
Determines the MIDI Controller message that the controller sends when you turn it on. When
you set a value for this parameter, the PC2R automatically assigns the same value to Off Ctrl.
On Value
Sets the value of the MIDI Controller message sent by the controller when you turn it on. The
value for all zones in the default setup is 127 or On. You can set any value from 0 to 127, but in
most cases, 127 is the most useful. You can also set a value of None, in which case the controller
sends no message. This is useful when you want the controller to do something in one zone but
not in another (although it probably makes more sense to set a value of None for On Ctrl).
Off Controller (Off Ctrl)
Determines the MIDI Controller message that the controller sends when you turn it off.
Off Value
Sets the value of the MIDI Controller message sent by the controller when you turn it off. The
value for all zones in the default setup is 0 or Off. You can set any value from 0 to 127, but in
most cases, 0 is the most useful. You can also set a value of None, in which case the controller
sends no message. This is useful when you want the controller to do something in one zone but
not in another (although it probably makes more sense to set a value of None for On Ctrl).
Entry State
Determines what MIDI Controller message, if any, the controller sends when you select the
setup. If the value is None, the controller sends no message. If the value is On, the controller
sends a message according to its settings for On Ctrl and On Value. If the value is Off, the
controller sends a message according to its settings for Off Ctrl and Off Value.
Exit State
Determines what MIDI Controller message, if any, the controller sends when you leave the
setup, by selecting either a different setup or a different performance mode. If the value is None,
the controller sends no message. If the value is On, the controller sends a message according to
its settings for On Ctrl and On Value. If the value is Off, the controller sends a message
according to its settings for Off Ctrl and Off Value.